NEWS

01. The operators of carton machinery and equipment are familiar with the structure, working principle and operating method of the equipment.

02. Machine operators shall not wear gloves to operate and shall not wear loose clothes.

03. Before turning on the machine, check the tools or other debris on the paper.Every time you start ringing the doorbell, you should guide the machine operator to lag behind other reactions.If you don't drive, after a while, then drive to ring the doorbell to make sure it is.When the starter is not allowed to run at high speed, the speed is zero, and the speed control knob gradually reaches the rated speed.

04.In the slotting part, according to the operating procedures, the blades of the slotting knife and paper cutter are very sharp, which can easily hurt the hand; the slotting knife falls in the middle of the groove.After adjusting the knife, pay attention to the paper cutter of the spatula.After adjusting the four knives, remember to lock and tighten the screws.If there is no exception during the rotation processing after each tuning lock, the operation can continue.When running at high speed, your left hand will encounter sharp edges, so be especially careful.In the production process, if you violate the operating procedures, it can easily cause injury.

05. Plates, erasers, and spatulas are used to remove dirt, impurities, paper, or cleaning machines. They should be turned off after turning on and reminded to prevent others from turning on by mistake.

06. Change the ink, clean the ink, do not touch the parts of the machine with your hands, and wipe off the stains with a cloth.；

07.Rollers, rubber rollers, and plate rollers are the heart of the printing machine. There must be no foreign objects or scratches in the rollers. They must be cleaned before work.

08.Regular gas, no oil cut-off or oil reduction.

09. The machine should be kept clean and work after cleaning to prevent corrosion and wear of parts.

10. If there is any abnormal noise in the machine, the inspection should be stopped immediately.The reason can be restarted.

11. Maintain a sensitive and reliable device, do not delete or adjust it at will, and move the device. If there is damage, it should be repaired in time.；

12. The appearance of the machine, the electric control cabinet, the motor and the electrical components should be kept clean, regularly checked for problems and aging, and hidden dangers should be found in time, and power outages should be checked for debugging and inspection.